CHIEF WMA1S, Руководство по установке

Страница: 8 / 16

WMA1S Installation Instructions
8
8. Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 8)
9. Repeat Steps 5 through 8 for each mounting hole.
Figure 8
10. Place wall bracket (B) over anchors and align mounting
holes in wall bracket with holes in anchors. (See Figure 9)
11. Insert 1/4-20 x 1-3/4" Phillips pan head screws (F) through
1/4" washer (E), corresponding hole on wall bracket and
into anchor (G) and tighten until flush against bracket. DO
NOT overtighten! (See Figure 9)
12. Repeat Step 11 for remaining 2 mounting holes.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Overtightening of
mounting hardware can damage the steel studs. DO NOT
overtighten mounting hardware!
Figure 9
Installation to Wall Bracket
1. Lift WMA1S assembly (A) up to wall bracket (B) and hook
upper plate over upper notches on bracket. (See Figure 10)
2. Slide lower plate into lower notches on bracket. (See
Figure 10)
Figure 10
3. Fasten WMA1S assembly (A) to wall bracket (B) using two
5/16-18 x 1/2" hex head cap screws (N) through two 5/16"
washers (S), the wall bracket and WMA1S. (See Figure 11)
Figure 11
Plastic Straps
Drywall
Anchor Metal Channel
Plastic Cap
8
Steel Stud
(side view)
Drywall
Anchor Metal Channel
(B)
(side view)
(F) x 3 11
Steel Stud
(E) x 3
Upper plate
(A)
Lower plate
1
1
2
(B)
(S) x 2
(N) x 2 3