WBAP
Installation Instructions
6
6.
Holding plastic straps on anchor (B3), pull anchor away
from wall until channel rests flush behind wall making sure
anchor channel is positioned vertically on stud. (See
Figure 5)
7.
Slide plastic cap on anchor (B3) towards wall until flange of
cap is flush with wall. (See Figure 5)
Figure 5
8.
Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 6)
Figure 6
9.
Repeat Steps 5 through 8 for each mounting hole.
10. Place WBAP bracket (A) over anchors and align mounting
slots in bracket with holes in anchors. (See Figure 7)
11. Place 1/4" flat washer (B2) onto 1/4-20 x 1-3/4" Phillips pan
head screws (B1).
12. Insert Phillips pan head screws (B1) with flat washer (B2)
through mounting slot in wall plate and into anchor (B3) and
tighten until flush against wall plate. DO NOT overtighten!
(See Figure 7)
13. Repeat Steps 5 through 12 for remaining 3 mounting holes.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Overtightening of
mounting hardware can damage the steel studs. DO NOT
overtighten mounting hardware!
Figure 7
14. Attach projector to WBAP following instructions included
with projector.
Plastic Cap
Steel Stud
Drywall
Anchor Metal Channel
(side view)
(B3) x 2
6
7
Plastic Straps
Steel Stud
Drywall
Anchor Metal Channel
Plastic Cap
(side view)
8
Steel Stud
Drywall
Anchor Metal Channel
Bracket (A)
(side view)
(B2) x 4
(B1) x 4
12
