TS318SU/TS318TU/TS325TU
Installation Instructions
16
Installing Display Without Interface Bracket
(100x100, 200x200 or 200x100)
CAUTION:
Using screws of improper diameter may
damage your display! Proper screws will easily thread into
display mounting holes.
1.
Select screw
diameter
by examining hardware (A-D) (4mm,
5mm, 6mm or 8mm) and comparing with mounting holes on
display.
CAUTION:
Using screws of improper length may damage
your display! Proper screws will have adequate thread
engagement without contacting bottom of display mounting
holes.
2.
Select screw
length:
•
Using your hand, insert SHORTEST length screw
of selected diameter (A1, B1, C1 or D1) into
display mounting hole. Do NOT thread screw into
hole at this time.
3.
Install two selected screws (A-D) into upper two holes on
back of display. (See Figure 24)
IMPORTANT ! :
If using M4 or M5 screws (A or B),
washer hardware (J, K and L) must be used to ensure
tight fit into the faceplate holes! For M4 screws (A), use
M4 washer (K) and shoulder washer (L). For M5 screws
(B), use M5 washer (J) and shoulder washer (L). (See
Figure 24)
Figure 24
4.
Hang display by two screws onto faceplate through either
inner or outer teardrop mounting holes. (200x200 mounting
pattern shown) (See Figure 25)
5.
Install two selected screws (A-D) through selected washer
hardware (H,J and K, if necessary), lower holes on faceplate
and into lower two holes on display. (See Figure 25)
6.
Tighten all hardware to ensure display is securely mounted.
Figure 25
Wall Cover Installation (Dual Stud)
1.
Turn wall cover (T) outward to allow outside of covers to
wrap around wall rail. (See Figure 26)
2.
Place wall cover (T) over wall rail. (See Figure 26)
Figure 26
(A-C) x 2
3
(L) x2 (with A and B ONLY!)
(J) x 2 with (B)
(K) x 2 with (A)
or
or
(D) x 2
4
5
(A-C) x 2
(200 x 200 shown)
(L) x 2 (with A and B ONLY!)
(J) x 2 with (B)
(K) x 2 with (A)
or
(D) x 2
or
(T) x 2
1
2
2
