CHIEF STMS1U, Руководство по установке

Страница: 9 / 12

Installation Instructions STMS1U
9
Attaching Screen to Wall Mount
NOTE:
Interface brackets (Y and Z) cannot be installed inside
the two upright brackets of wall mount! Both interface
bracket must be installed to the outside of the upright
brackets. (See Figure 8)
Figure 8
1. Hang screen onto the top rail of the mount (X). (See Figure
9)
•
Move latch on top of interface brackets to OPEN
position and hang top hook of interface bracket (Y and
Z) onto the top rail of the mount (X). (See Figure 9)
NOTE:
The screen initially installs into the "service mode" to
allow easy cable access.
2. Adjust screen and rails to desired viewing position.
3. Route cables between wall and rails.
CAUTION:
PINCH POINTS! Keep fingers, hands and
cables out of pinch point areas.
4. Pull downward on the pull cords and swing inward toward
wall, latching interface brackets to lower rail and fastening
bottom of screen to the mount.
5. Attach end of pull cord (a magnet) to mount so it does not
extend beyond bottom of screen. (See Figure 9)
Figure 9
Adjustments
Roll/Height Adjustment of Wall Brackets
NOTE:
The height adjust wall brackets allow adjustment of
+ 1/2".
1. Turn to right (tighten) to raise side of screen. (See Figure 10)
2. Turn to left (loosen) to lower side of the screen.
Figure 10
Interface brackets cannot be installed inside
the two upright brackets of the wall mount!
[Brackets Y and Z shown]
upright brackets
Latch in
6
Pull
cords
5
5
2
OPEN
position
Raises screen
Lowers screen
1
2
(S)
(Screen not shown for clarity)