CHIEF STMS1U, Руководство по установке

Страница: 7 / 12

Installation Instructions STMS1U
7
Installing to a Concrete Wall
1. Determine the center of the TV screen, and where it should
be located on the wall.
2. Line up the notches on mount (X) with center of screen
marking to determine vertical center. (See Figure 1)
3. Measure up 6" (152.4mm) from the center point to mark
location of the upper mounting slot. (See Figure 1)
4. Mark the wall through upper mounting slot. (See Figure 3)
Figure 3
5. Drill one 3/8" x 3-1/2" (9.5mm x 88.9mm) pilot hole at each
marking.
6. Install one anchor (P) into pilot hole using a hammer,
making sure that the anchor is flush with the wall.
7. Partially install one 5/16 x 2-1/2" flanged lag bolt (N) into
pilot hole but do not tighten to wall.
8. Hang mount (X), aligning upper mounting slot over lag bolt.
(See Figure 3)
9. Place one slotted washer (Q) over flanged lag bolt. (See
Figure 3)
10. Tighten lag bolt to secure mount (X) to wall at upper
mounting slots.
11. Mark the attachment point for the lower mounting slot. (See
Figure 3)
12. Drill 3/8" x 3-1/2" (9.5mm x 88.9mm) pilot hole at marking for
lower mounting hole. (See Figure 3)
13. Use one 5/16 x 2-1/2" flanged lag bolt (N) and one 5/16"
slotted washer (Q) to attach the mount to the wall through
the lower mounting hole. (See Figure 3)
14. Slide rails to approximate center of screen location.
Locking Rails (Optional)
1. Lock rails into place using two 1/4-20 x 3/4" set screws (T) on
mount upright (X) and the 1/8" hex key (R). (See Figure 4)
2. Repeat for remaining mount upright.
NOTE:
To easily install upper set screw against upper rail,
place set screw (T) onto hex key (R), and feed up into
hole while turning to tighten.
Figure 4
11
5
6
4
12
x 2
(P) x 2
10
7 10 (N)
(Q) 9
(Q)
13
13 (N)
(X)
(T) x 4 1
(R)
(R)