Installation Instructions
MTSAV, -BV, -CV
5
ASSEMBLY AND INSTALLATION
WARNING:
EXCEEDING WEIGHT CAPACITY CAN
RESULT IN SERIOUS PERSONAL INJURY OR DAMAGE
TO EQUIPMENT! It is the installer’s responsibility to make
sure the combined weight of display and mount does not
exceed 100 lbs (45.4 kg).
WARNING:
TURNING DISPLAY CAN CAUSE DAMAGE
TO SURROUNDING OBJECTS. Make certain location
provides enough area for the display to rotate ± 270° without
being obstructed, or lock display to a lesser rotation before
rotating for rotating for the first time.
Figure 1
NOTE:
The MTS is shipped with the display rotation set at the
maximum of 270°. Display rotation can be adjusted to
0, 10, 20, 30, or 40° and locked if installation location
requires it.
Figure 2
Installation
1.
Locate a flat surface (thickness of 1/2" to 1-5/8") on which
to mount the MTS assembly.
2.
Mark four mounting hole locations on underside of mounting
surface.
3.
Drill four 1/4" dia. (6.35mm) holes through underside of
mounting surface at marks.
4.
Secure MTS post (B) to mounting surface using four 10-24
button head cap screws [(S) - for mounting surfaces up to
3/4" thickness; or (T) - for mounting surfaces from 3/4" to
1-5/8" thickness]. (See Figure 3)
Figure 3
Base
MTS
x 4
x 4
Mounting
Hole
Locations (4)
2
3
Can adjust to tighten
or loosen tension.
or
(T)
(S)
x 4
(W) x 4
Mounting
Surface
4
MTS
