Instruction Manual
MSP-DUK9000
7
PROJECTOR INTERFACE PLATE
ATTACHMENT PROCEDURES
Attach the bottom portion of the universal projector mount to the
projector as follows.
1.
Loosen, but do not remove, acorn nuts securing arms of the
universal projector mount (see Figure 5).
2.
Adjust front and back legs to mounting points. If there are only
three mounting points, remove one leg from the mount.
3.
Adjust feet (rotate right to raise, left to lower), making sure to
allow for proper air ventilation and the mount is level with the
projector [some feet may need to be at different heights to keep
the mount level (M3, M4, M5 and M6 screws and washers
included)].
4.
If the mounting holes are closer than a five inch diameter, raise
the feet all the way up so they will swing under the universal
interface bracket.
WARNING: You must use proper attaching hardware and
installation procedures. Failure to use proper
attaching hardware and installation procedures
may result in equipment damage or serious per-
sonal injury.
5.
Determine proper screw size and depth (M3, M4, M5 and M6
included) for projector mounting and correct washers (M3,
M4, M5 and M6 included). If proper screw size is not included
with this unit, you must purchase the proper attaching hard-
ware separately.
6.
Secure (loosely) back two legs of universal projector mount to
the projector at mounting locations.
7.
Secure (loosely) front two legs of universal projector mount to
the projector at mounting locations.
8.
Move the universal projector mount to the center of gravity of
the projector.
9.
Make sure the threaded studs on the plate are square in relation
to the front of the projector.
10. Tighten screws and acorn nuts securing the legs of the univer-
sal projector mount.
11. Tighten hex nuts on the threaded studs to secure inserts at
proper positions.
Figure 6. Install the Projector Interface Plate on Your Projector
Figure 5. Projector Interface Plate to
Universal Ceiling Projector
Mount Attachment
