CHIEF MSP-DCCPPNR, Руководство по установке

Страница: 13 / 14

Installation Instructions MSP-DCCPPNR
13
SWING ARM TENSION ADJUSTMENT
Swing arm tension is pre-set at the factory and is adjusted to
accommodate displays with weights near the top of the mounts
capacity.
If smaller displays are used it may be difficult to reposition the
display after mounting. Swing arm tension can be adjusted to
compensate for smaller display by:
NOTE: The display must be mounted prior to adjusting swing
arm tension.
1. Locate the ajustment bar and wrench provided with the
mount.
2. Place adjustment bar into socket head cap screw located at
swing arm pivot point. (see figure 15)
NOTE: The display may need to be repositioned in order to
gain access to the tension adjustment screw(s).
3. Using the wrench provided with the mount, turn adjust-
ment bar clockwise to increase swing arm tension or coun-
terclockwise to reduce swing arm tension. (see figure 16)
and (see figure 17)
NOTE: Small adjustments of 1/8 turn or less are typically all
that is required to achieve desired tension.
4. Check swing arm tension. If desired tension is present,
tension adjustment is complete. If additional tension
adjustment is required, repeat steps 2 and 3 until desired
tension is achieved.
NOTE: If changing from a smaller display to a larger display
may be necessary to increase swing arm tension.
Adjustment
Bar
Wrench
Socket Head
Capscrew
Figure 15. Pivot Arm Tension Adjustment
Reduce
Figure 16. Reduce Swing Arm Tension
Increase
Figure 17. Increase Swing Arm Tension