CHIEF MSP-DCCPPNR, Руководство по установке

Страница: 11 / 14

Installation Instructions MSP-DCCPPNR
11
SWING ARM ADJUSTMENTS
The dual swing arms are shipped installed in the center of the
top and bottom mounting brackets, which is the standard
mounting configuration.
The top and bottom mounting brackets have slotted holes,
allowing for lateral adjustment of the dual swing arms.
After the top and bottom mounting brackets have been
installed between two wood studs 16” on center, the swing
arms can be adjusted or moved off center, depending on the
location of the mount, the size of the display, and the lateral
movement needed to rotate the display.
The swing arms can be adjusted, as follows:
• Adjusting the Swing Arms Off-Center
With no disassembly required, you can adjust the swing
arms up to 1-inch to the left of center or up to 1-inch to the
right of center.
• Reconfiguring the Swing Arms Left of Center
With some disassembly and re-assembly required, you can
move the swing arms to the left of center by reconfiguring
the mount. Use the first and third slotted holes in the top
and bottom mounting brackets.
• Reconfiguring the Swing Arms Right of Center
With some disassembly and re-assembly, you can move
the swing arms to the right of center by reconfiguring the
mount. Use the third and fifth slotted holes in the top and
bottom mounting brackets.
Adjusting the Swing Arms Off Center
Perform this procedure to adjust the dual swing arm mount
configuration.
1. Remove the display from the mount.
2. Loosen four bolts (two on the top and two on the bottom)
securing the swing arm assembly to the top and bottom
mounting brackets (see Figure 12).
3. Move the swing arm assembly to desired location.
4. Tighten the bolts.
5. Install the display on the mount.
Figure 12. Swing Arm Adjustment –
Slightly Off Center
Top Bolts