CHIEF MSP-DCC9000, Инструкция по эксплуатации

Страница: 11 / 12

Instruction Manual MSP-DCC9000
11
PROJECTOR ALIGMNMENT INSTRUCTIONS
The Universal Ceiling Projector Mount can be adjusted for vertical
elevation (pitch), horizontal tilt (roll), and rotation (yaw). Once the
desired position is located and all the screws of the Universal Ceil-
ing Projector Mount are tightened, the projector may be removed
from its location and replaced using the four thumb nuts without
loosing the registration of the projector. Align the projector as fol-
lows:
Pitch
Adjust pitch using the pitch adjustment screw located on each end
of the Universal Ceiling Projector Mount. Adjust pitch as follows:
1. Loosen the pitch adjustment screw on each side of the Univer-
sal Ceiling Projector Mount (see Figure 9).
2. Adjust projector angle to desired pitch.
3. Tighten the two pitch adjustment screws.
Roll
Adjust roll using two 1roll adjustment screws on the face and back
of the Universal Ceiling Projector Mount. Adjust roll as follows:
1. Loosen the roll adjustment screw on the face and back opposite
the pitch clamp (see Figure 9).
2. Adjust projector to desired roll position.
3. Tighten the roll adjustment screw.
Yaw
Adjust yaw by threading or unthreading the Universal Ceiling Pro-
jector Mount on the 1” pipe. Adjust yaw as follows:
1. Loosen the set screw (see Figure 9).
WARNING: Do not turn the Universal Ceiling Projector
Mount to the end of the pipe threads. The Universal Ceiling
Projector Mount, Projector Interface Plate, and projector
will fall from the pipe if the Universal Ceiling Projector
Mount is unthreaded too far.
2. Adjust projector by turning the Universal Ceiling Projector
Mount on the 1” pipe to the desired yaw position.
NOTE: Overtightening the set screw may damage threads and
make adjusting yaw difficult. Make sure yaw adjustment is set
before tightening set screw.
3. Tighten the set screw.
Figure 9. Pitch, Roll, and Yaw Adjustment