LW46/47/48/49/50/55UxP
Installation Instructions
10
2.
Carefully lay flat panel face down into the depth-adjustable
outer frame. (See Figure 7)
Figure 7
3.
Center flat panel on opening within outer frame in both
vertical and horizontal directions.
NOTE:
Measuring from inside edges to display edges assists
in centering the display within opening.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Using screws of
improper size may damage your display. Properly sized
screws will easily and completely thread into display
mounting holes. If spacers are required, be sure to use longer
screws of the same diameter.
4.
Select screw
diameter
by examining hardware (BA-BL) and
comparing with mounting holes on flat panel.
5.
Select spacers:
•
Spacers are
NOT
required if mounting holes are not
recessed and hinged frame can lay flat against flat
panel.
•
Spacers (BM, BN)
ARE
required if mounting holes are
recessed, or if protrusions prevent hinged frame from
laying flat.
•
Spacers may also be used between the hinged frame
and flat panel to create more space for AV
components, or to accommodate thinner flat panels.
(See
Depth Adjustment
section for further
information.)
6.
Select screw
length:
•
By hand, insert SHORTEST length screw of selected
diameter (BA, BD, BG, or BJ) through universal washer
(BO--if required), hinged frame, spacer (BM, BN--if
required), into flat panel mounting hole. Do NOT thread
screw into hole at this time.
IMPORTANT ! :
The M8 screws do
NOT
require a
washer. Use the universal washer (BO)
ONLY
with the
M4, M5 or M6 screws.
•
Proper screw length requires base of screw head to
protrude above flat washer a
distance equal to or
greater than the screw diameter.
If screw length is
inadequate, select longer screw. Select
shortest
screw
which will protrude the required distance.
7.
Place hinged frame onto back of flat panel and match the
VESA pattern on flat panel to the hinged frame mounting
slots. Also match the threaded studs in outer frame to the
hooks on the hinged frame. (See Figure 8)
8.
Use selected screws (BA-BL), washers (BO--if required),
and spacers (BM, BN--if required), to connect hinged frame
to back of flat panel. (See Figure 8)
Figure 8
NOTE:
The outer frame depth may be adjusted between
3" - 5" to make room for a variety of different flat panel
thicknesses. (See Figure 9)
•
This outer frame adjustable depth can also be used to
make more space between the back of the flat panel
and wall for AV component storage.
•
The 4 Phillips screws removed in Step 1 can be
replaced with four 10-24 x 2-3/4" Phillips screws (CD)
for larger depth adjustments.
Figure 9
2
Depth-adjustable
outer frame
Flat panel
2
NOTE: Use universal washer (BO)
(BO)
(BM and/or BN)
8
(BA-BL) x 4
Outer
frame
ONLY with M4, M5 or
M6 screws.
9
Thumb nuts x 4
10
Previously
(CD) x 4
removed
OR
[Flat panel not shown]
Two washers
should remain
between hook
and outside
panel
