KWP130 / KWP230
Installation Instructions
6
4.
Adjust Centris bracket (B) to desired height and tighten the
knob closest to the array (A1) to secure Centris bracket to
array. (See Figure 6)
NOTE:
If installing a KWP230, adjust two Centris brackets (B)
to desired height following instructions in Step 4.
Figure 6
5.
Install 1/4-20" square nut (F) into the top of the back groove
of array (A1 or A2) and line up with top hole on plate. (See
Figure 7)
6.
Install 1/4-20 x 1/2" button head cap screw (D) into upper
hole on array and through square nut (F). (See Figure 7)
Figure 7
Display Installation
The mounting holes on the back of your display will either be
flush with
the back surface, or
recessed into
the back surface.
Refer to the applicable installation procedure.
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components attached to this accessory does not exceed
40 lbs (18.14 kg) for the KWP130, and 16.5 lbs (7.5 kg) per
display for the KWP230.
FLUSH MOUNTING HOLES
CAUTION:
Using screws of improper size may damage
your display! Proper screws will easily and completely thread
into display mounting holes.
CAUTION:
Inadequate thread engagement in display may
cause display to fall! Back out screws ONLY as necessary to
allow installation of Centris bracket!
1.
Ensure Centris bracket is able to swivel and tilt easily, yet
still be tight enough to hold display in desired position.
Adjust as required before proceeding. See
Adjustments
section for detail.
2.
Using Phillips screwdriver, carefully install two M4 x 12mm
Phillips pan machine screws (L) into the
upper
mounting
holes on the display. Thread screws completely into
display, then back out 3 complete turns.
3.
Pick up and align display so that screws (L) (installed on the
back of the display in the previous step) fit into the mounting
holes on the Centris bracket; rotate the bracket as required.
Lower the display firmly into place. (See Figure 8)
Figure 8
4.
Using Phillips screwdriver, install two remaining M4 x 12mm
Phillips pan machine screws (L) through the
lower
mounting
holes in Centris bracket into the display.
5.
Tighten all four screws (L). Do not overtighten!
RECESSED MOUNTING HOLES
1.
Carefully place display face down on protective surface.
2.
Determine depth of recessed mounting holes relative to
back surface of display (against which Centris head will
contact).
Height adjustment
knob
(F)
(D)
6
5
(KWP130 shown)
(A1 or A2)
(L) x 2
(B)
