Installation Instructions
KWP130 / KWP230
5
Assembly And Installation
Installation to Wall
1.
Determine location for mount keeping in mind display size,
extension, height adjustment (if applicable), and pitch/roll
requirements. Wall bracket (C) MUST be installed into
wood stud.
2.
Using wall bracket (C) as a template, drill two 1/8" diameter
pilot holes through top and bottom holes of bracket and into
wall structure. (See Figure 1)
Figure 1
3.
Using Phillips screwdriver, install two #10 x 2-1/2" Phillips
pan tapping screws (E) through two #10 washers (G),
bracket (C), and drywall into wood stud. Ensure bracket (C)
is vertical, then tighten screws (E). (See Figure 1)
IMPORTANT ! :
Overtightening screws (E) may cause
bracket (C) to compress into soft wall surface, resulting in
difficult mount installation or improper engaging of set
screw in Step 5.
4.
Insert top of mount (A1 or A2) over lip on top of bracket (C).
Swing mount (A1 or A2) down flush against wall. (See
Figure 2)
Figure 2
5.
Tighten set screw using 5/32" hex key (H). Ensure set screw
engages
back
side of bracket (C) to properly secure mount.
(See Figure 3)
Figure 3
Centris Bracket to Array
IMPORTANT ! :
If you will be installing a display with
RECESSED mounting holes, then proceed to
Display
Installation
section
before continuing
with this mount
installation procedure.
1.
Install 1/4-20" square nut (F) into back groove of array (A1
or A2) and line up with bottom hole on plate. (See Figure 4)
2.
Install 1/4-20 x 1/2" button head cap screw (D) into lower
hole on array mount (A1 or A2) and through square nut (F).
Figure 4
3.
Slide one Centris bracket (B) over array (A1). (See Figure 5)
NOTE:
If installing a KWP230, slide two Centris brackets (B)
onto the array (A2).
Figure 5
(E) x 2
(G) x 2
(C)
2
3
(A1 or A2)
(C)
(KWP130 shown)
Set Screw
(C)
(D)
(F)
1
2
(KWP130 shown)
3
(KWP130 shown)
