Installation Instructions
K4S120-210-310
9
4.
Using Phillips screwdriver, install two M4x12 mm Phillips
pan machine screws (F3) through the
lower
mounting holes
on faceplate into the display. (See Figure 8)
Figure 8
5.
Tighten all four screws (F3). Do not over-tighten!
NOTE:
If roll adjustment is desired for center faceplate, do not
tighten screws.
6.
Repeat Steps 1-5 for other displays.
7.
Proceed to Cable Management Section.
Recessed Mounting Holes
NOTE:
If faceplate does not fit into recessed area of display,
proceed with the steps in this section.
1.
Determine depth of recessed mounting holes relative to
back surface of display (against which faceplate will
contact).
2.
Select proper length spacer and screw from table below:
NOTE:
All spacers used should be the same length. If the
recess depths result in multiple spacer lengths, then
select the longer spacer.
CAUTION:
Using screws of improper size may damage
your display! Proper screws will easily and completely thread
into display mounting holes.
3.
Using Phillips screwdriver, carefully install two selected
screws (F1 or F2) through selected spacers (F4 or F5) into
the
upper
mounting holes on the display. Thread screws
completely into display, then back out 3 complete turns.
(See Figure 9)
4.
Pick up and align display so that screws (F1 or F2) (installed
on the back of the display in the previous step) fit into the
mounting holes on the faceplate. Lower the display firmly
into place. (See Figure 9)
Figure 9
5.
Slide two remaining selected spacers (F4 or F5) in between
faceplate and display, positioning them over the
lower
two
mounting holes. (See Figure 10)
6.
Install two remaining selected screws (F1 or F2) through
lower
two mounting holes on faceplate, selected spacers
(F4 or F5) into the
lower
mounting holes on the display. (See
Figure 10)
Figure 10
7.
Tighten all four screws. Do not over-tighten!
IF recess DEPTH is: THEN use spacer:
AND screw:
3/8” or less
F4 (3/8” long)
F2 (M4 x 20mm)
More than 3/8” up to
and including 3/4”
F5 (3/4” long)
F1 (M4 x 30mm)
faceplate
(array arm not shown for clarity)
(F3) x 2
4
(F4 or F5) x 2
(F1 or F2) x 2
3
faceplate
(array arm not shown for clarity)
4
(F4 or F5) x 2
(F1 or F2) x 2
6
faceplate
(array arm not
shown for clarity)
