K4S120-210-310
Installation Instructions
8
8.
Use two #10-32 x 1" button head cap screws (C) to secure
two handle (E) to array arm (G). (See Figure 5)
NOTE:
Keep in mind the size of the display when selecting
which holes to use to attach the handles.
Figure 5
9.
Install two wall bracket covers (H) onto wall bracket. (See
Figure 6)
Figure 6
Display Installation
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located on the K4S120-210-310 mounts up to
(and including) the display does not exceed 15 lbs (6.8 kg)
per display.
CAUTION:
Using screws of improper size may damage
your display! Proper screws will easily thread into display
mounting holes.
NOTE:
Supplied screws (F1, F2 and F3) may not fit properly
for all displays. See display’s operating instructions for
details.
Flush Mounting Holes
1.
Position faceplate in desired mounting position. Adjust as
required before proceeding. See Height Adjustment Section
for details.
2.
Using Phillips screwdriver, carefully install two M4 x 12mm
Phillips pan machine screws (F3) into the
upper
mounting
holes on the display. Thread screws completely into display,
then back out 3 complete turns. (See Figure 7)
Figure 7
3.
Pick up and align display so that screws (F3) (installed on
the back of the display in the previous step) fit into the
mounting holes on the faceplate. Lower the display firmly
into place. (See Figure 7)
(G)
(B) x 2
8
(K4S210 shown)
(E)
(H) x 2
9
9
faceplate
(array arm not shown for clarity)
(F3) x 2
2
