K1C1KRA204-K1C2KRA204
Installation Instructions
6
Assembly And Installation
Assembly to Desk
1.
Affix five rubber feet (G) to underside of column plate of
assembly (A). (See Figure 1)
Figure 1
2.
Locate a flat surface (thickness of 3/4” minimum to 4"
maximum) on which to mount the column plate.
3.
If mounting hole does not already exist on desk, drill
mounting hole in desk at desired mounting location.
IMPORTANT ! :
Mounting hole must be a minimum of
5/16” in diameter and a maximum of 2"!
4.
Position mount on desk so that center hole of column plate
is centered over grommet hole. (See Figure 2)
5.
Insert 5/16-18 x 5" bolt (F) through grommet bracket (E),
grommet hole and thread into center hole on underside of
column plate. (See Figure 2)
Figure 2
6.
Tighten 5/16-18 x 5" bolt (F) until grommet bracket (E) is
tightened against underside of desk and column mount is
securely mounted to desk. (See Figure 2)
Display Installation
1.
Remove quick release faceplate from mount by pressing
quick release tab and sliding faceplate off mount. (See
Figure 3)
Figure 3
WARNING:
Only remove display from mount when the
display can be lifted up from the mount! DO NOT remove
display unless the display is in the upright position! See
Display Removal section for details.
2.
Carefully place display face down on protective surface.
3.
Connect faceplate to display
For flush mounting hole installation:
•
Using Phillips screwdriver, carefully install four
M4x14mm screws (B) through corresponding
holes on faceplate and into the mounting holes on
the display. (See Figure 4)
Figure 4
(column plate)
1
(G) x 5
(A)
6
(F)
4
5
(E)
quick release tab
1
1
(B) x 4
quick release
faceplate
(for flush mounting holes)
3
