8
Installation Instructions
FWD-111
Flush Mount – 75mm/100mm Pattern
To flush mount the display using the 75mm/100mm mounting
hole pattern, do the following:
1.
Install two M4 x 12mm screws (20) into the top mounting
holes on the display (see Figure 7 and Figure 8).
2.
Align the mounting holes on the Centris mount with the
screws installed on the display. Hang the display on the
mount.
3.
Install two remaining M4 x 12mm screws (20) into the
bottom mounting holes on the display.
4.
Secure the display to the mount by tightening all four
M4 x 12mm screws (20).
5.
Proceed to “CABLE MANAGEMENT” on page 10 and
the “ADJUSTMENTS” on page 10 and perform those two
procedures to complete the installation process.
Recessed Mount – 75mm/100mm Pattern
To recess mount the display using the 75mm x 100mm mount-
ing hole pattern, do the following:
NOTE: Use one of the following screw and spacer combina-
tions: (30 with 40) or (50 with 60).
CAUTION:
If your display uses a screw size other than
M4 X 20mm or M4 X 30mm, DO NOT use the
M4 X 20mm or M4 X 30mm screws. Using the
wrong screws could result in damage to your dis-
play.
1.
Select four screws (30 or 50) and four spacers (40 or 60),
depending on your display model.
2.
Place four spacers (40 or 60) over the mounting holes on
the back of your display (see Figure 7, Figure 8
and Figure 9).
3.
Align the mounting holes on the Centris mount with the
spacers installed on the back of your display.
4.
Secure the mount to your display using the four screws (30
or 50) that were selected in step 1.
5.
Perform the procedure to “Install FWD-111 on Wall
Bracket” on page 7.
6.
Proceed to “CABLE MANAGEMENT” on page 10 and
the “ADJUSTMENTS” on page 10 and perform those two
procedures to complete the installation process.
30 or 50
40 or 60
Figure 9. Recessed Mount – 75mm/100mm Pattern
Figure 8. Flush Mount – 75mm/100mm Pattern
20
75mm/75mm
VESA Pattern
(Inside Mounting Holes)
100mm/100mm
VESA Pattern
(Outside Mounting Holes)
Figure 7. 75mm/100mm VESA Mounting Patterns
