CHIEF Flexlink KXC Series, Руководство по установке

Страница: 9 / 16

Installation Instructions KXC Series
9
2. Remove column cap from column.
3. Slide arms (F) into column grooves at desired mounting
height.
4. Tighten two screws on base of each arm to secure KXC420
arms (F) to column. (See Figure 9)
5. After all arms have been installed, install re-install column
cap to top of column.
Figure 9
Display Installation
1. Remove quick release faceplate from mount by pulling
quick release lever and sliding faceplate off mount. (See
Figure 10)
Figure 10
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located between the KXC Series Monitor Arm
up to (and including) the display does not the weight limits
listed in the table below. Use with products heavier than the
maximum weight indicated may result in collapse of the
mount and its accessories causing possible injury.
2. Carefully place display face down on protective surface.
3. Connect faceplate to display
For flush mounting hole installation:
• Using Phillips screwdriver, carefully install four
M4x10mm screws (B) through corresponding
holes on faceplate and into the mounting holes on
the display. (See Figure 11)
Figure 11
For recessed mounting hole installation:
• Place four spacers (D) on top of mounting holes
on back of display. (See Figure 12)
• Using Phillips screwdriver, carefully install four
M4x20mm screws (C) through corresponding
holes on faceplate, spacers (D) and into the
mounting holes on the display. (See Figure 12)
Figure 12
(F) x 2
3
4
2
3
(KXC420)
remove
5 re-install
quick release lever
1
1
MODEL Max Weight
Allowed for EACH Max Weight
Capacity of
KXC220
25 lbs
(11.34 kg) 50 lbs
(22.68 kg)
KXC330 20 lbs
(9.07 kg) 60 lbs
(27.2 kg)
KXC420
20 lbs
(9.07 kg) 80 lbs
(36.3 kg)
(for flush mounting holes)
(B) x 4
quick release
faceplate
3
(for recessed mounting holes)
(C) x 4
(D) x 4
quick release
faceplate
3