Installation Instructions
FCASFP / FMSIML / FMSITL
9
INSTALL INTERFACE BRACKETS TO
DISPLAYS
1.
Place displays face down on a soft, non-abrasive surface.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Using screws of
improper size may damage your display. Properly sized
screws will easily and completely thread into display
mounting holes. If spacers are required, be sure to use longer
screws of the same diameter.
2.
Select screw
diameter
by examining hardware (A-C and
F-H) and comparing with mounting holes on display. (See
Figure 6)
3.
Select spacers:
•
Spacers are
NOT
required if mounting holes are
not recessed and interface brackets (J and K) can
lay flat against display.
•
Spacers (E)
ARE
required if mounting holes are
recessed, or if protrusions prevent interface
brackets (J and K) from laying flat.
4.
Select screw
length:
(See Figure 6)
•
By hand, insert SHORTEST length screw of
selected diameter (A or F) through 1/4" washer
(D), bracket (J or K), selected spacer (E, if
required), into display mounting hole. Do NOT
thread screw into hole at this time.
•
Proper screw length requires base of screw head
to protrude above flat washer a
distance equal to
or greater than the screw diameter.
If screw
length is inadequate, select longer screw. Select
shortest
screw which will protrude the required
distance.
5.
Align the center of the interface brackets (J and K) with
center of screen. (See Figure 6)
NOTE:
The diamond-shape hole in the bracket corresponds to
the center of the mount.
6.
Use selected screws (A-C or F-H), washers (D) and spacers
(E), if necessary, to connect interface brackets (J and K) to
back of display. (See Figure 6)
Figure 6
(E) x 4, if required
(K)
(J)
(A-C or F-H) x 4
6
(D) x 4
Match diamond with
center of display
5
