FCASFP / FMSIML / FMSITL
Installation Instructions
6
ATTACH DISPLAYS TO MOUNTING RAIL
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! The displays must
be located approximately evenly across the length of the rail.
1.
Ensure that the latch mechanisms on interface brackets (R
and S) are already raised to the OPEN position. (See
Figure 1)
CAUTION:
BEFORE adding displays to the mounting rails,
ensure end caps (FMSECAP) are in place at BOTH ends of
mounting rail following instructions included with the
FMSECAP.
2.
While supporting both sides of display, lower display onto
mounting rail, hooking top of interface brackets onto top of
mounting rail. (See Figure 4)
3.
Lower the latch mechanism on both interface brackets to
lock bracket in place. (See Figure 4)
Figure 4
4.
Repeat for remaining interface bracket.
Interface Bracket Adjustment
CAUTION:
ALWAYS
keep a small distance between
screens when making adjustments! Damage to screens
possible if placed too close together.
Tilt
The interface brackets allow 0° to 20° tilt, and can be locked at
0°, 10° and 20° tilt.
5.
If necessary, loosen button head tilt friction bolt (located on
side of interface bracket). (See Figure 5)
6.
Adjust tilt as required. (See Figure 5)
7.
The tilt may be locked at 0°, 10° and 20° using one
10-24 x 5/8" Phillips head screw (P) and one 10-24 lock nut
(Q) per interface bracket. (See Figure 5)
8.
Tighten tilt friction bolt as necessary.
Figure 5
OPTIONAL: Security
1.
OPTIONAL
: Add padlock (not included) to each interface
bracket to lock display to mounting rail. (See Figure 6)
Figure 6
2
3
Latch
mechanism
Lock at
Lock at
Lock at
Tilt
friction
bolt
5
6
8
(Displays not shown)
7
(P)
(Q)
0° tilt
10° tilt
20° tilt
Padlock
(Optional)
(Displays not shown)
