CHIEF EGX-SF2, Руководство по установке, Страница: 8 / 12

EGX-SF2 Installation Instructions
8
5. Replace the outlet box into the EGX-SF2 housing. (See
Figure 4)
6. Rotate outlet box clockwise until it is in proper position to be
secured to the EGX-SF2 housing. (See Figure 4)
7. Tighten two Phillips screws to secure outlet box to EGX-
SF2 housing. (See Figure 4)
Figure 4
8. Install two clips (C) onto either side of EGX-SF2 housing.
(See Figure 5)
Figure 5
9. Insert EGX-SF2 housing into drywall opening. (See Figure
6)
Figure 6
10. Tighten screws on the two drywall clamps so that they are
locked in place against the drywall, and not laying flat
against the EGX-SF2. (See Figure 7)
Figure 7
11. Remove Phillips flat head screw and locking washer from in
between outlets. (See Figure 7)
12. Install faceplate (B) onto EGX-SF2 using one Phillips flat
head screw and locking washer removed in Step 11. (See
Figure 8)
NOTE:
Make sure LED light on outlet box lines up with hole
location on faceplate (B). (See Figure 8)
Figure 8
Outlet Box Use
NOTE:
The “PROTECTED” light indicates that the surge
protection circuitry is active and operational. (See
Figure 9)
Figure 9
6
7
x2
5
(C) x 2
9
9
Wall
Clamp
10
x 2
(Front View)
Wall
Clamp
Wall
Clamp
11
12
(removed screw and
(B)
LED light
washer) x 1
“PROTECTED”
indicator light