SKU 93652
For technical questions, please call 1-800-444-3353;
PAGE 15
Troubleshooting section at end of manual.
the water supply. Turn on the water, disengage the Trigger Safety Lock
(23), and squeeze the Trigger (24) until water flows out of the Spray Gun
(21) without sputtering. This removes air from the system and allows the unit
to properly perform. Failure to follow this Step can damage the Pump.
7.
Test the cleaning capabilities and the run before starting your cleaning project as
explained on page 17. Turn the Power Switch (2) to the “ON” position. The Motor
(16) will briefly run when the Power Switch is first turned on to build up
pressure and then go to standby until the Trigger (24) is squeezed. Do not
allow the unit to remain idle for more than a minute or two, as it will build up
heat when it is on standby mode.
8.
Point the Nozzle in a safe direction. Then, disengage the Trigger Safety Lock
(23) and squeeze the Trigger (24). Turn the unit’s Power Switch (2) to the “OFF”
position whenever the Spray Gun (21) is not in use. Clean the area, following the
tips contained in the
“OPERATING TIPS” section.
9.
When finished spraying, fully engage the Trigger Safety Lock (23) and turn the
Power Switch (2) to its “OFF” position. Then, turn off the water supply.
WARNING! Do not disconnect the High Pressure Hose (20) or water inlet
hose until all pressure is discharged safely.
10.
IMPORTANT! When turning off the Pressure Washer after use, high pressure
will remain inside the unit, its High Pressure Hose (20), and the water inlet hose.
Point the Spray Gun (21) in a safe direction and hold the Trigger (24) down until
water stops flowing from the Spray Gun. Then, release the Trigger and remove
the Extension Wand (25). The High Pressure Hose and water inlet hose can be
disconnected after the pressure is released.
11.
Store the Pressure Washer and all accessories in accordance with the directions
in the
“INSPECTION, MAINTENANCE, AND CLEANING” section of this manual.
IF ANY UNEXPECTED PROBLEMS ARISE, PLEASE REFER TO THE
TROUBLESHOOTING SECTION AT THE END OF THIS MANUAL.
IMPORTANT!
Never allow the Pressure Washer to sit idle with the
Power Switch (2) on for longer than two minutes.
OPERATING TIPS
BECOME FAMILIAR WITH YOUR PRESSURE WASHER
1.
Before beginning work, set aside enough time to familiarize yourself with this
