background image

Page 3

For technical questions, please call 1-800-444-3353.

SKU 34552 

        

Pull down on both handles until the bead slide off 

10. 

the rim. 

Remove mounting components and flip the tire 

11. 

off, forcing the tire off the rim.
Remove Pin and remove the Forcing Handle 

12. 

assembly from the Locking Nut.

Warning!

13. 

 Sharp edges can be left on the rim. 

Be sure to wear heavy-duty work gloves and to 

use caution when handling.
Lubricate each bead with to facilitate sliding of 

14. 

the bead over the rim (Windex® window cleaner 

is a good lubricant substitute.)
Push down on tire until there is enough room to 

15. 

place the ball end of the Mounting/Demounting 

Tool (11) under the bead on the opposite end of 

the tire.  See Figure 5. 

 

 

 

 

 

 

 

 

 

 

 

 

 

Push handle of Mounting/Demounting Tool down, 

16. 

raising the bead above the rim.  See Figure 5.
With ball end still under the bead, pull handle of 

17. 

Mounting/Demounting Tool around in a clockwise 

direction.  Hold tire to prevent it from turning.  

See Figure 5.
Raise tire so that lower bead is just under the 

18. 

upper lip of the rim.  See Figure 6. 

 

 

 

 

 

 

 

 

 

 

 

 

Position the ball end of Mounting/Remounting 

19. 

Tool under lower bead of tire.  
Push down on handle to push lower bead above 

20. 

the rim.
Pull handle of Mounting/Remounting Tool 

21. 

clockwise to remove bottom bead from the rim.  

See Figure 6.

Warning! 

22. 

 Failure to use Bead lubricant when 

removing the tire from the rim may result in 

damage to the bead.

installing tire operation

To mount a new or repaired tire, lubricate the 

1. 

inside and outside both tire beads.
Push the lower bead onto the rim as far as it will 

2. 

go without forcing it.  See Figure 7. 

 

 

 

 

 

 

 

 

 

 

 

 

 

note:

3. 

 With proper use of bead lubricant, the 

first bead should slide complete onto the rim.  

In cases where it does not, the Mounting/

Demounting Tool can be used to install the first 

bead.
Place the cut-out center of the Mounting/

4. 

Demounting Tool over the Locking Nut.  See 

Figure 8. 

 

 

 

 

 

 

 

 

 

 

 

 

 

Figure 5

Mounting/Demounting Tool (11)

Figure 6

Mounting/Demounting  

Tool (11)

Clockwise rotation

Figure 7

Base (15)

Figure 8

Mounting/Demounting  

Tool (11)

Отзывы: