For technical questions, please call 1-800-444-3353;
troubleshooting section at end of manual.
Page 22
SKU 94164
WELD DIAGnOSIS
ExCESS OR BURn-thROUGh
Weld droops on top and
underneath, or falls through
entirely, making a hole.
pROpER
Weld is visible underneath and
bulges slightly on top.
InADEqUAtE
Weld does not contact the joint
fully, just on the surface.
Weld penetration
pOSSIBLE CAUSES AnD SOLUtIOnS
Excessive material at weld:
1.
Reduce wire feed speed.
Overheating:
2.
Increase welding speed and ensure that
welding speed is kept steady.
pOSSIBLE CAUSES AnD SOLUtIOnS
Workpieces too thick/close:
1.
Joint design must allow weld to reach
bottom of groove and allow proper welding
procedures.
Incorrect welding technique:
2.
Maintain
1
/
2
” or less stickout.
Keep arc on leading edge of weld
puddle.
Hold gun at proper angles as stated under
Holding The Torch on page 19.
Insufficient weld material:
3.
Increase wire feed speed.
Insufficient weld heat:
4.
Reduce Welding Speed.
Cross seCtions
Weld not Adhering properly
Gaps present between weld and previous bead or
between weld and workpiece. See areas below.
pOSSIBLE CAUSES AnD SOLUtIOnS
Dirty workpiece:
1.
Make certain that workpiece is clean
and free from oil, coatings, and other
residues.
Insufficient weld material:
2.
Increase wire feed speed.
Incorrect welding technique:
3.
Place stringer bead at correct place in joint.
Adjust workpiece position or weld angle
to permit proper welding at bottom of
workpiece.
Pause briefly at sides when using weave bead.
Keep arc on leading edge of weld
puddle.
Hold gun at proper angles as stated under
Holding The Torch on page 19.
Cross
seCtion
Bend at joint
pOSSIBLE CAUSES AnD SOLUtIOnS
Improper clamping:
1.
Make sure that pieces are clamped
securely in place.
Make tack welds to help hold pieces.
Excessive heat:
2.
Weld a small portion and allow to cool
before proceeding.
Reduce wire feed speed.
Increase weld speed.
Cross
seCtion