Chicago Pneumatic PHB 3-14, Руководство по эксплуатации

Страница: 15 / 20

The torque varies with the pressure, as for example:
Tightening torque (Nm) Pressure (bar)
160 70
225 100
315 140
Troubleshooting
Solution Cause Problem
Verify that the
power source meets
the specifications Improper power
source Posthole Borer will
not operate
Check oil level.
Check system for
leaks Oil level too low
Use hydraulic oil
with correct
viscosity Incorrect hydraulic
oil viscosity
Allow oil to warm up
to operating
temperature Cold hydraulic oil Posthole Borer
operates slowly or
erratically
See the operating
manual for the
power source and
set the flow and
pressure Power source not
adjusted correctly
Check oil level.
Check system for
leaks Oil level too low
See the operating
manual for the
power source in
order to remove air
from the system Air in the hydraulic
system
Use hydraulic oil
with correct
viscosity Incorrect hydraulic
oil viscosity
Depressurize the
hydraulic system
and switch the hose
connections Hose connections
reversed Posthole Borer
operates backwards
Storage
♦ Disconnect the machine’s hoses from the power
source, see "Start and stop".
♦
Make sure that the machine is properly cleaned
before storage.
♦
Always store the machine in a dry place.
Disposal
A used machine must be treated and scrapped in
such a way that the greatest possible portion of the
material can be recycled and any negative influence
on the environment is kept as low as possible.
Before a used machine is scrapped it must be
emptied and cleaned from all hydraulic oil. The
remaining hydraulic oil must be deposited and any
negative influence on the environment is to be kept
as low as possible.
15 3392 5231 01b | Original instructions
Safety and operating instructions PHB 3-14