4. Set the hydraulic by-pass valve (D) to the OFF
position.
D
5. Pull out the starter cord (E) until it resists. Release
the handle so the starter cord goes back again,
and then pull the starter cord until the engine
starts.
E
6. As the engine warms up, gradually move the
choke control (C) to the OPEN position.
Before usage, the power pack must be allowed to
warm up to its working temperature for several
minutes.
Stopping the engine
1. Turn the engine switch (A) to position OFF.
2. Turn off the fuel by setting the fuel control (B)
to the OFF position.
When taking a break
♦
During all breaks you must place the machine in
such a way that there is no risk for it to be
unintentionally started. Make sure to place the
machine on the ground, so that it can not fall.
♦
In the event of a longer break or when leaving the
workplace: Switch off the power supply and then
bleed the machine by activating the start and stop
device.
Maintenance
Regular maintenance is a basic requirement for the
continued safe and efficient use of the machine.
Follow the maintenance instructions carefully.
♦
Before starting maintenance on the machine,
clean it in order to avoid exposure to hazardous
substances. See “Dust and fume hazards”
♦
Use only authorised parts. Any damage or
malfunction caused by the use of unauthorised
parts is not covered by warranty or product
liability.
♦
When cleaning mechanical parts with solvent,
comply with appropriate health and safety
regulations and ensure there is satisfactory
ventilation.
♦
For major service of the machine, contact the
nearest authorised workshop.
♦
After each service, check that the machine's
vibration level is normal. If not, contact the nearest
authorised workshop.
Every day
Never perform maintenance when the power pack
is running.
♦
Clean and inspect the machine and its functions
each day before start working.
♦
Conduct a general inspection for leaks and
damage and wear.
♦
Change damaged parts immediately.
♦
Replace worn components in good time.
♦
Never use the equipment if you suspect that it is
damaged.
♦
Never strike or abuse the equipment.
♦
Make sure that all the attached and related
equipment, such as hoses and POD (power on
demand) are in good condition.
15
3392 5183 01b | Original instructions
Safety and operating instructions
PAC P13
