ASSEMBLY INSTRUCTIONS
NOTE: For additional references to the parts listed below, refer to the Assembly
Diagram on page 11 of this manual.
To Attach The Polishing Disc And Wool Cover:
1.
Caution: Prior to installing the Wool Compounding Bonnet (part #44), make sure
the Polisher/Sander is disconnected from its electrical power source.
2.
Place the Adaptor (part #1) on the Spindle (part #3) of the Polisher/Sander, and
place the Wool Compounding Bonnet (part #44) on the Adaptor (See Figure B,
and Assy. Diagram.)
3.
Depress the Brake Pin (part #18) to keep the Spindle (part #3) from turning, and
hand screw the Adaptor (part #1) onto the Spindle. (See Figures B, C, and Assy.
Diagram.)
4.
Then, use the Spanner (part #43) provided to keep the Adaptor (part #1) from
turning, and firmly hand tighten the Wool Compounding Bonnet onto the Adaptor.
(See Figures B, C, and Assy. Diagram.)
ADAPTOR (#1)
SPINDLE (#3)
BRAKE PIN (#18)
WOOLCOMPOUNDING BONNET (#44)
SWITCH (#33)
BRUSH CAP (#40)
CARBON BRUSH (#41)
BRUSH HOLDER (#42)
(Qty. 2 EACH)
VARIABLE SWITCH (#31)
SWITCH LOCK
BACK HANDLE (#39)
FIGURE B
SKU 46507
PAGE 6
REV 09/02
REV 06/05
IMPORTANT
Carefully inspect the condition of the accessory before use and check the accessory
continually during use. If any damage is noted, stop immediately and replace the
accessory with an undamaged one. Harbor Freight Tools cannot be held responsible
for damage caused by using a damaged accessory on this tool.
