SKU 93255
For technical questions, please call 1-800-444-3353
.
Page 4
Battery Precautions
1.
Read all instructions and warnings
on the Battery before charging the
battery.
2.
To avoid accidents, charge the
supplied Battery only. Use only the
supplied charging adapters for
charging the internal Battery.
3.
Replace a dead Battery with only the
same type (See Specifications, page
2).
4.
Do not expose the Battery to rain or
wet conditions.
5.
To avoid damage of cable and plug,
never pull the cable to disconnect
the Adapter.
6.
Do not use the Adapters if the cable
or plug are damaged.
7.
Repairs should be carried out by a
qualified technician.
8.
Do not touch the Battery poles with
any conductive source.
9.
Do not store the Battery in a box with
other metal objects.
10. Do not throw the Battery in a fire or
in the general trash. Contact your
local hazardous waste disposal
authority for proper disposal.
11. Do not drain the Battery completely
before recharging. Recharge fully
when low, or quarterly when stored.
12. Always recharge the Battery when
tool performance begins to diminish.
Severe heat is most destructive to a
Battery; the more heat generated,
the faster the Battery loses power.
A Battery that gets too hot can be
Unpacking
When unpacking, check to make sure
the following parts are included. If any
parts are missing or broken, please call
Harbor Freight Tools at the number on
the cover of this manual.
Car Plug Adapter
AC/DC Adapter
Shoulder
Strap
Main Unit
permanently damaged. Never over-
discharge a Battery by using the tool
even after tool performance is
decreasing. When tool performance
begins to diminish, stop the tool, and
recharge the Battery.
13. Always remove the Battery from the
Spotlight before perfor ming
inspection, maintenance, cleaning
procedures, or storage.
Warning: The warnings, cautions, and
instructions discussed in this
instruction manual cannot cover all
possible conditions and situations
that may occur. It must be understood
by the operator that common sense
and caution are factors which cannot
be built into this product, but must be
supplied by the operator.
REV 01/07
