Page 18
SKU 98199
For technical questions, please call 1-800-444-3353.
troubleshooting
problem
possible Causes
likely Solutions
Tool will not start
No power at outlet.
1.
Cord not connected.
2.
Check power at outlet.
1.
Check that cord is plugged in.
2.
Tool operates
sporadically or at
low power
Low power supply or improper
1.
extension cords.
Worn or cracked Carbon
2.
Brushes.
Check power supply and power cords.
1.
Check Carbon Brushes. Replace if damaged
2.
or worn.
Wood burns at
ends when cut
Dirty Blade.
1.
Material is binding.
2.
Clean Blade using blade cleaner or mineral
1.
spirits.
Check position of work material on Table.
2.
Material must be flat, flush against Fence
and supported on ends.
Material frays or
chips out.
Finished side is down
1.
Blade is chipped or dull.
2.
Blade is inappropriate for
3.
material.
Material is unsupported.
4.
Always have finished side of material up or
1.
facing you. Bottom and back side are prone
to chip out.
Check for damaged teeth. Sharpen or
2.
replace blade.
Check blade manufacturer’s
3.
recommendations for material being cut. For
cross cutting hard wood and for precision
cuts use a thin kerf blade with 60 or more
teeth.
Use a thin piece of scrap material, such
4.
as 1/4” plywood, underneath or behind the
material to support the edges of the material
as it is being cut.
Blade binds,
slowing or
stopping saw.
Material is misaligned on
1.
the saw or ends are not
supported.
Material is wet, contaminated
2.
or inappropriate blade is
being used.
Material must be flat on table, flush against
1.
the fence and supported on both ends.
Check condition of material and check
2.
compatibility of blade to material.
Follow all safety precautions whenever diagnosing or servicing the tool.
disconnect power supply before service.
pleaSe read tHe Following CareFullY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE OR SHE IS qUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
qUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE
UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION
OF REPLACEMENT PARTS THERETO.
