Page 16
SKU 98199
For technical questions, please call 1-800-444-3353.
Figure 7
8. Reinstall a new Blade on the Arbor.
(
See Figure 6.
) Be sure to match the
direction marked on the new blade
with the direction marked on the saw
Blade Housing.
Replace the Outer Flange and Arbor
9.
Bolt. Tighten the Arbor Bolt securely
using the Wrench by turning it
counterclockwise.
Rotate the Center Cover back into
10.
place and tighten the Center Cover
Fixing Bolt using the Wrench by
turning it clockwise.
Release the Locking Pin.
11.
adjusting the Fence
The Fence holds the work piece in a
1.
fixed position while the Table and or
the blade assembly are adjusted in a
miter or bevel angle.
To make accurate cuts, the Fence
2.
must be perpendicular (at a 90º
angle) to the Saw Blade.
Before beginning work, make a test
3.
cut on scrap material with the Table
set at 90º.
Check the cut with an accurate
4.
square. You can also reverse the two
pieces, hold the cut ends together,
and hold a good straight edge along
the side of the pieces.
If either test reveals that the cut is not
5.
a true 90º angle, you must adjust the
Fence before beginning work.
To adjust the Fence, first unplug the
6.
tool.
Lower the blade assembly and lock it
7.
in place using the Locking Pin.
Lay a reliable carpenter’s square on
8.
the table with one edge along the
blade and the other along the Fence.
Any inaccuracy should be visible.
NOTE: The square must contact the
surface of the blade, not the teeth, for
an accurate reading.
The Fence is held in place with
9.
bolts at each end. Loosen the bolts
slightly, and gently tap the Fence into
position using a soft mallet. Retighten
the bolts and make another test cut.
Repeat the process until the Fence is
adjusted accurately.
Once the Fence is accurately
10.
adjusted, tighten the bolts firmly in
place. Recheck one last time, then
proceed to work.
adjusting the miter table
indicator
After you have checked or adjusted
1.
the fence to be sure it is at 90º to the
Blade, you must check the accuracy
of the Miter Table Angle Indicator.
Loosen the screw holding the Angle
2.
Indicator in place. Rotate it until the
Figure 6
