SKU 97588
For technical questions, please call 1-800-444-3353.
Page 18
troubleshooting
problem
possible causes
likely solutions
Tool will not start
No power at outlet.
1.
Cord not connected.
2.
Carbon Brushes may be worn or
3.
damaged.
Check power at outlet.
1.
Check that cord is plugged in.
2.
Inspect Carbon Brushes and replace if
3.
necessary.
Tool operates
slowly or
erratically.
Carbon Brushes may be worn or
1.
damaged.
Excess pressure applied to
2.
workpiece.
Inspect Carbon Brushes and replace if
1.
necessary.
Decrease pressure, allow tool to do
2.
the work.
Tool does not
grind, sand or
brush effectively.
Disc accessory may be loose on
1.
Spindle. Check tightness of Outer
Flange Arbor Nut or threaded disc
accessory on Spindle.
Disc accessory may be damaged,
2.
worn or wrong type for the
material.
Be sure disc accessory is of correct
1.
dimension and Outer Flange Arbor Nut
is tight.
Check condition and type of disc
2.
accessory. Use only proper type of
disc accessory in good condition.
Follow all safety precautions whenever diagnosing or servicing the
tool. Disconnect power supply before service.
please reaD tHe FOllOWing careFully
THE MANUfACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLy
DIAGRAM IN THIS MANUAL AS A REfERENCE TOOL ONLy. NEITHER THE MANUfACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE OR SHE IS QUALIfIED TO MAkE ANy REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
QUALIfIED TO REPLACE ANy PARTS Of THE PRODUCT. IN fACT, THE MANUfACTURER AND/
OR DISTRIBUTOR ExPRESSLy STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD
BE UNDERTAkEN By CERTIfIED AND LICENSED TECHNICIANS, AND NOT By THE BUyER. THE
BUyER ASSUMES ALL RISk AND LIABILITy ARISING OUT Of HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT Of HIS OR HER
INSTALLATION Of REPLACEMENT PARTS THERETO.
