Page 16
Item 97360
For technical questions, please call 1-888-866-5797.
MAINTENANCE AND SERVICING
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool to its “OFF” position and unplug the
tool from its electrical outlet before performing any inspection,
maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
1.
WARNING!
Make sure the Power Switch
(37) of Tile Saw is in its “OFF” position and
that unit is unplugged from its electrical
outlet before performing any inspection,
maintenance, or cleaning procedures.
Any service not listed below should only
be performed by a qualified technician.
2.
Before each use, inspect the general
condition of the Tile Saw. Check for
loose screws, misalignment or binding of
moving parts, damaged electrical wiring,
damaged Hoses, and any other condition
that may affect its safe operation. If
abnormal noise or vibration occurs, have
the problem corrected before further
use. Do not use damaged equipment.
3.
Before each use, inspect the Saw Blade
(4). Using a dull Saw Blade will cause
excessive wear on the Motor, and will
not produce a satisfactory cut. Replace
with a new Saw Blade when needed.
4.
Before each use, inspect mounting
Screws on all Safety Covers and the
Arbor Nut (6) on the Motor Arbor. If
necessary, retighten loose hardware.
5.
After each use, immediately clean the
Water Pump (7) to keep dried debris from
sticking to the Filter and Impeller which
will obstruct the water flow. To clean the
Water Pump, remove the Outer Cover (7A).
Remove the Filter. Then, remove the Inner
Cover (7C) to expose the Impeller. Use
a small brush and clean water to remove
any debris on the Filter and Impeller. If
necessary, replace the old Filter. When
finished, replace the Inner Cover, Filter,
and Outer Cover. (See Assy. Diagram.)
6.
If water delivery volume is reduced, clean
the Filter and the Impeller. If no water is
being delivered or is still restricted, the
Delivery Tube or Nozzle maybe blocked. If
the Pump does not buzz or deliver any water,
even when Delivery Tube is disconnected,
the Pump may need to be replaced.
7.
To replace the Water Pump (7), disconnect
the Power Supply Cord and remove the
Water Tray (67). Locate the Pump Plug
Cover (118) on the inner left side of the
Frame. Unscrew and remove the Knob
(119), Spring Washer (95), Washer (102),
and Lock Nut (107) from the Pump Plug
Cover. Remove the Pump Plug Cover to
expose the Pump Cable (117). Disconnect
the Pump Cable from the Water Pump. Next,
disconnect the Pump Connector (115) from
the Water Pump. Then, remove the old
Water Pump. Install the new Water Pump,
following the previously mentioned Steps
in reverse order. (See Assy. Diagram.)
8.
To clean the exterior parts: Use only a clean
cloth and mild detergent to clean the body
of the Tile Saw. Use a wet/dry vacuum
cleaner or compressed air to clean the
Motor (1) ventilation slots. Do not immerse
any electrical part of the tool in liquid.
9.
Empty all water from Saw before
storing. Ice crystals will damage the
Pump if the unit contains water in
freezing temperatures. Store the Tile
Saw indoors in a dry, frost-free room.
