SKU 94849
For technical questions please call 1-800-444-3353
Page 10
troubleshooting
Tool will not operate or operates slowly:
Battery may need to be charged. Recharge the Battery.
1.
Too great a load is being placed on the tool. Try a slower speed on the 6-Speed
2.
Selector. The caulk may be dried up in the tube, or the tip may be plugged. Check
condition of cartridge and caulk, replace if necessary.
Battery loses charge quickly:
A new Battery will not hold a charge as long as older ones. Completely deplete and
recharge Battery Pack several times to extend its charge life.
Caulk squirts out back of cartridge:
The caulk may be dried up in the tube, or the tip may be plugged. Check condition
of cartridge and caulk, replace if necessary.
The trigger is locked in place and won’t move:
The Locking Button (7) may be in the wrong position. Push it in, and try squeezing
the trigger again. See Figure 1 page 5.
Maintenance
Keep your tool clean and dry. Wipe dirt and grease from it if it becomes dirty. Re-
1.
move any excess caulk, adhesive or filler while it is still wet. Do not use solvents on
the plastic parts of this tool.
Do not allow your tool, Battery or Charger to become wet.
2.
Do not leave Battery in Charger unattended for long periods of time.
3.
When not in use, remove the Battery and store both Tool and Battery in a dry, se-
4.
cure location.
07j
