Page 9
For technical questions, please call 1-800-444-3353.
Item 94338
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Operating Instructions
Read the ENTIRE IMpORTANT SAFETy INFORMATION
yy
section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO pREVENT SERIOUS INJURy
REVENT SERIOUS INJUR
REVENT SERIOUS INJUR FROM A
yy
ccIDENTAL OpERATION:
Make sure that the Trigger is in the off-position and unplug the tool from its
electrical outlet before performing any procedure in this section.
Attaching Sandpaper to the Backing pad (28)
1. Press the tab on the
clamp Wire (17)
inward on
both sides of the unit and swing the clamps on
both sides up, out, and down. See photo below.
2. Cut the sandpaper to fit the 3-5/8” W x
7-3/8” L
pad (22)
, with a little extra to
overlap and fit under the
clamp Wire (17)
.
Do not use torn or frayed sandpaper.
3. After wrapping the overlapped edges of
sandpaper under the
clamp Wire (17)
, push the
clamp Wire (17)
back into it’s locking position,
thus trapping the ends of the sandpaper in
front and rear of the sander. The sandpaper
should now be held securely in place.
lamp Wire (17)
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
General Operating Instructions
1. Make sure that the Trigger is in the
off-
off
off position, then plug in the tool.
2. Hold the Sander securely with both hands. Turn
on the Sander by turning on the Switch (3).
3. Always run the Sander for a few seconds
before contacting the workpiece.
4. Contact the workpiece with minimal pressure. If
the Sander is not removing enough material,
try a grittier piece of sandpaper. If you want to
remove a lot of material fast, use a belt sander.
Note:
All sanders leave sanding marks on
the workpiece. To minimize sanding marks,
always try to sand with the grain of the wood.
5. Occasionally check the sandpaper for tears,
wear, or fraying. Replace if necessary.
6. To prevent accidents, turn off the tool and
unplug it after use. Clean, then store the
tool indoors out of children’s reach.
Содержание 94338
Страница 1: ......
