Page 15
skU 92280
For technical questions, please call 1-800-444-3353
INSPECTION, MAINTENANCE, AND CLEANING
WARNING!
Disconnect the wire to the Spark Plug of the Engine before performing
any inspection, maintenance, or cleaning procedures. Any repairs must be done by a
qualified electrician or mechanic.
1. Before each use, inspect the general condition of the Generator. Check for loose
screws, misalignment or binding of moving parts, cracked or broken parts, damaged
electrical wiring, and any other condition that may affect its safe operation. if
abnormal noise or vibration occurs, have the problem corrected before further use. do
not use damaged equipment.
2. Periodically recheck all nuts, bolts, and screws for tightness.
3. store in a clean and dry location.
4. For Engine maintenance and troubleshooting, refer to the robin subaru Engine
operator’s Manual.
5. after the Engine has cooled down, remove the remaining gasoline into a gasoline
container before storing the unit.
6. After the first five hours of use, drain and replace the Engine oil. After that, replace the
oil after every 25 hours of use. Check the Hour reading on the Hour Meter.
6. Push in the Choke Control rod.
7. Plug in the extension cords or appliances, making sure that the appliance (loads) are
turned off.
refer to the section on Extension Cords on page 9. do not overload the Generator.
Calculate the total wattage of the appliances. The Generator has a maximum power
output is 11,000 watts (total from all outlets being used).
8. Begin to turn on the connected appliances.
The Engine governor will regulate the throttle automatically depending on the
electrical load applied to the generator. if electricity to one of the outlets stops, it could
be that the circuit was overloaded. Check the appliance(s) wattage, then push in on
the corresponding Circuit Breaker reset Button to resume power.
9. When you are finished using the Generator:
- Turn off, then unplug all appliances.
- stop the engine by turning the Engine on/off switch to the off position.
- Turn the Gas valve clockwise and close it completely.