SKU 91852
For technical questions, please call 1-800-444-3353.
PAGE 19
make sure the Saw Blade (4) does not contact the bottom of the Work
Table (87) or any other part of the Saw Base.
(See Figure P)
WORK TABLE (87)
KERF BOARD
(151)
SAW BLADE (4)
FIGURE P
LONG BOLT (133B)
SHORT
BOLT (133A)
7.
If the Saw Blade (4) touches the Work Table (87) or any other part of the Saw
Base, turn the two Bolts (133A,133B)
clockwise
to raise the Saw Blade slightly
until it clears.
(See Figure P.)
To Adjust The Miter Angle:
1.
WARNING! Prior to performing this procedure, make sure the Power
Cord of the Miter Saw is unplugged from its electrical outlet.
2.
The miter angle of a cut may be adjusted 0 - 45 degrees to the right or left. To
do so, loosen the Fasten Knob (153) located at the front of the Work Table (87).
(See Figure Q.)
3.
Move the Work Table (87) to the right or left until the desired miter angle of cut is
indicated by the Miter Scale located on the Base (100). Then, retighten the Fas-
ten Knob (153) to lock the Miter Saw in place.
(See Figure Q.)
FASTEN KNOB
(153)
BASE (100)
WORK TABLE
(87)
FIGURE Q
REV 12/05
