SKU 91852
For technical questions, please call 1-800-444-3353.
PAGE 15
To Assemble/Adjust Additional Accessories:
1.
A workpiece Clamp Assembly (96, 99, 101, 109, 111) can be installed by inserting
the Assembly into the hole located in the Guide Fence (97). Once inserted, lock the
Assembly in place with a Wing Screw (103). To clamp the workpiece to the Work
Table (87) of the Miter Saw, turn the Adjusting Knob (111) clockwise.
(See Figure K.)
2.
A workpiece Holder (105) can be inserted into each side of the Base (100), adjusted
for the desired length, and locked in place with a Wing Screw (103). The Holders
should be used as supports when cutting longer length workpieces.
(See Figure
K.)
3.
The Baffle Plate (104) can be attached to the workpiece Holder (105) and locked in
place with a Wing Screw (103). Once attached and locked in place, the Baffle Plate
allows you to make repeated cuts of the same length. To do so, loosen the Wing
Screw (103) that holds the Holder (105) in place. Measure the distance from the
Saw Blade (4) to the Baffle Plate and, when the desired length of cut is determined,
lock the Holder in place with the Wing Screw.
(See Figure K.)
4.
Guide Fence Adjustment:
Loosen all four Bolts (108) on the back side of the
Guide Fence (97). Using a square (not included), make sure that the fence is at a
perfect right angle to the blade when the blade is set at 0° angle. Also, ensure that
the blade does not contact the fence in any of the blade’s positions. Tighten the
Bolts (108) to lock the Guide Fence in position.
FIGURE K
BAFFLE PLATE
(104)
BAFFLE PLATE
(104)
HOLDER
(105)
HOLDER
(105)
WING SCREW
(103)
WING SCREW
(103)
WING SCREW
(103)
CLAMP ASSY.
(96, 99, 109, 111)
CLAMP ASSY.
(96, 99, 109, 111)
FENCE
GUIDE
(97)
