SKU 91757 For technical questions please call 1-800-444-3353 PAGE 9
11.
Keep your body positioned to either side of the Saw Blade (83), but not in
line with the Saw Blade. “Kickback” can cause the Saw to jump backwards.
12.
Causes and operator prevention of “kickback”: Kickback is a sudden reaction
to a pinched, bound, or misaligned Saw Blade (83), causing an uncontrolled
Saw to lift up and out of the workpiece toward the operator. When the Saw Blade
is pinched or bound tightly by the kerf closing down, the Saw Blade stalls and the
Motor reaction drives the tool rapidly toward the operator. If the Saw Blade
becomes twisted or misaligned in the cut, the teeth at the back edge of the Saw
Blade can dig into the top surface of the workpiece, causing the Saw Blade to
climb out of the kerf and jump back toward the operator. Kickback is a result of
tool misuse and/or incorrect operating procedures or conditions and can
be minimized by taking proper precautions as given below:
A. Maintain a firm grip with both hands on the Saw, and position your body
and arm to allow you to resist kickback forces.
B. When the Saw Blade (83) is binding, or when interrupting a cut for any
reason, release the Power Switch (9) and hold the Saw motionless in
the workpiece until the Saw Blade comes to a complete stop. Never
attempt to remove the Saw from the workpiece or pull the Saw backward
while the Saw Blade is in motion or kickback can occur.
C. When restarting the Saw in the workpiece, center the Saw Blade (83) in
the kerf and check that the saw teeth are not engaged into the
workpiece. If the Saw Blade is binding, it may walk up or kickback from the
workpiece as the Saw is restarted.
D. Support large panels to minimize the risk of Saw Blade pinching and
kickback. Large panels tend to sag under their own weight. Supports must
be placed under the panel on both sides, near the line of cut and near the
edge of the panel.
E. Do not use a dull or damaged Saw Blade (83). Unsharpened or improperly
set Saw Blades produce a narrow kerf causing excessive friction, Saw Blade
binding and kickback.
F. Make sure all Saw adjustments are tight and secure before making a cut.
If Saw adjustments shift while cutting, it may cause binding and kickback.
G. Use caution when making a pocket cut into existing walls or other blind
areas. The Saw Blade (83) may cut objects that can cause kickback. Also,
check to make sure there are no electrical wires or cables in the cutting path.
