SKU 91511
PAGE 11
Saw Blade (6) from the Spindle of the Wet Tile Saw. Then, install a new diamond
Saw Blade with a
7” diameter, 5/8” round arbor hole, and rated at a minimum
3,600 RPM. (See Figure D.)
6.
NOTE: When installing the new Saw Blade (6), make sure the directional arrow
shown on the Saw Blade is pointing toward the front of the Wet Tile Saw.
(See Figure D.)
7
Replace the Outer Washer (28). Then, firmly tighten the Blade Lock Nut (27)
counterclockwise to secure the Saw Blade (6) in place. (See Figure D.)
FIGURE D
SAW BLADE
(6)
OUTER WASHER
(28)
BLADE LOCK NUT
(27)
LEFT CUTTING TABLE
(26)
GUARD SUPPORT
(4)
GUARD SUPPORT SCREW
(5)
BLADE GUARD
(2)
WING NUT
(3)
WING NUT SCREW
(1)
To Attach The Saw Blade Guard:
1.
Align the mounting hole in the Guard Support (4) with the mounting hole in the
inner edge of the frame of the Wet Tile Saw. Then secure the Guard Support to
the frame, using one Guard Support Screw (5).
(See Figure D.)
2.
Secure the Blade Guard (2) to the top portion of the Guard Support (4), using
one Wing Nut Screw (1) and one Wing Nut (3).
(See Figure D.)
