Chicago Electric 91222, Руководство пользователя

Страница: 8 / 16

Page 8 For technical questions, please call 1-800-444-3353. SKU 91222
Specifications
Electrical Input 120 V~ / 60 Hz / 4.5 A
Motor No Load Speed 11,000 RPM
Accessory Size
4″ (100 mm) Max.
Diameter
accepts either
5/8″ or 7/8″ Arbor Hole
Arbor Diameter
5/8″ with 7/8″
Arbor Adapter
Spindle Thread 5/8″ x 11 TPI
Setup - Before Use:
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug
the tool from its electrical outlet before assembling
or making any adjustments to the tool.
Note: For additional information regarding the
parts listed in the following pages, refer to the
Assembly Diagram near the end of this manual.
Assembly
Installing the Wheel Guard
TO PREVENT SERIOUS INJURY:
Do not operate this tool without the
Wheel Guard properly installed.
1. Loosen the Wheel Guard Nut.
2. Slide the collar of the Wheel Guard
over the rim of the Gear Housing.
3. Rotate the Wheel Guard as needed to
shield you during the planned work.
4. Tighten the Wheel Guard Nut securely.
5. Check the Wheel Guard to ensure it is firmly in
place. Adjust if necessary before proceeding.
Installing the Side Handle
TO PREVENT SERIOUS INJURY: Do not
operate this tool with one hand only or without
the Side Handle properly installed.
6. The Side Handle may be installed in one of two
positions, on either side of the Gear Housing.
7. Screw the threaded end of the Side Handle
into the selected position. Tighten
securely before beginning work, as shown below.
Operating Instructions
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off
and unplug the tool from its electrical
outlet before installing accessories.
Installing a Non-threaded Grinding Wheel
1. The Grinding Wheel MUST be:
• rated to at least 11,000 RPM.
• no larger than 4″ in diameter.
• fitted with a 5/8 or 7/8″ round arbor hole.
• 1/4″ thick or less.
• suitable for surface grinding, not edge grinding.
• dry and clean.
• proven undamaged by inspection and
by the ring-test explained below.
2. Press in and hold the LOCK PIN (12) to
prevent the Spindle from turning.
Side Handle
(29)
E194601
5H92