Page 9
For technical questions, please call 1-800-444-3353.
Item 67119
SAFET
y
O
PERA
TION
M
AINTENAN
c
E
SETUP
Operating Instructions
Read the ENTIRE IMPORTANT SAFETy INFORMATION
yy
section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURy
TO PREVENT SERIOUS INJUR
TO PREVENT SERIOUS INJUR FROM A
yy
ccIDENTAL OPERATION:
Make sure that the Trigger is in the off-position and unplug the tool from its
electrical outlet before performing any procedure in this section.
Installing Bits
Chip
Shield
(70)
Spindle Lock Button (46) Spindle
Figure 2
1. Unthread the Screw (85) holding the Chip Shield
(70) in place and remove the Chip Shield.
2. Lock the Plunge Lock Lever (32) in
place to keep the shaft stationary.
3. Depress the Spindle Lock Button (46) and rotate
the Spindle until it locks in place. Keep the
Spindle Lock Button depressed through step 6.
4. Use the Spanner Wrench (51) to
loosen the Collet Nut (50).
5. Insert the bit all the way into the Collet.
cAUTION! Bits are sharp, Handle with care.
6. Securely tighten Collet Nut.
7. Release the Spindle Lock Button.
8. Pull up the Lock Lever to free the shaft.
9. Replace the Chip Shield.
cutting Depth Adjustment
Depth
of Cut
Depth
Adjusting
Bolt (29)
Depth
Stop
Turret
(67)
Screw
(85)
Depth
Stop
Bar (30)
Figure 3
The depth of cut is equal to the distance between
the lower end of the Depth Adjusting Bolt (29) and
the section of the Depth Stop Turret (67) directly
below the Depth Stop Bar (30). First, install the
bit you will use for the cut, then adjust the Router
as follows to set up the desired cutting depth.
1. Loosen the Thumb Screw so that the
Depth Stop Bar (30) can slide freely.
2. Rotate the Adjusting Knob (26) until
the Depth Adjusting Bolt (29) protrudes
about 1/4” from the Depth Stop Bar.
3. Rotate the Depth Stop Bar to the left so that
the indexing mark along the top of the Bar
is visible from under the Pointer (28).
4. Hold the Bar and rotate the Adjusting Knob
until the Zero mark along the base of the
adjusting Knob aligns with the indexing line.
5. Rotate the Depth Stop Turret
(67) to the lowest setting.
Содержание 67119
Страница 1: ......