Page 10
For technical questions, please call 1-800-444-3353.
Item 67119
SAFET
y
O
PERA
TION
M
AINTENAN
c
E
SETUP
6. Loosen the Plunge Lock Lever (32).
7. Lower the Router body until the bit
just touches the workpiece.
8. Tighten the Plunge Lock Lever.
9. Use one of the following two ways
to adjust the router depth:
Increment Guide
Pointer
(28)
Thumb Screw
Figure 4
•
Position the Depth Adjusting Bolt (29), so that
it is touching the Depth Stop Turret (67). Slide the
Pointer (28) to zero on the Increment Guide, then
raise the Depth Stop Bar to the desired height
using the Pointer and the Increment Guide. Tighten
the Thumb Screw to hold the Stop Bar in place.
•
Or, using a piece of wood the thickness
of the desired cut, place the piece of wood on
the Lowest level of the Depth Stop Turret (67).
Adjust the Depth Stop Bar (29) so that the
Depth Stop Bolt (29) rests on the piece of wood
and tighten in place with the Thumb Screw.
Note:
For marginal depth adjustments, raise
For marginal depth adjustments, raise
the Depth Adjusting Bolt (29) (located inside the
Depth Stop Bar) in fine increments by turning
the Adjusting Knob (26) to set the exact desired
depth of cut. Use the Pointer (28) along with the
increment guide to help make the adjustment.
10. Loosen the Plunge Lock Lever and allow the
router to return to its original position.
Edge Guide
Thumb Screws (81)
Edge Guide
Figure 5
To attach the Edge Guide when making straight cuts:
a. Loosen the Thumb Screws (81).
b. Slide the bars on the Edge Guide into
the slots on the Base of the Router with
the fence facing the workpiece.
Note:
The Edge Guide can be inserted into
The Edge Guide can be inserted into
either side of the tool to make cuts along
the left or right side of the material.
c. Adjust the distance between the router bit and the
fence of the Edge Guide to the desired setting.
d. Tighten the Thumb Screws (81).
Dust Extraction Adapter
1. If desired, attach a vacuum cleaner hose
to the Dust Extraction Adapter (62).
2. Be sure the hose, vacuum cleaner, and power
cord are out of the way and properly secured so
they will not tip over or interfere with the Router
or workpiece. If they cannot be positioned safely,
they should not be used with the Router.
3. Turn on the vacuum before turning on the Router.
4. Empty the vacuum cleaner as needed
only after turning off and unplugging both
the vacuum cleaner and the Router.
Содержание 67119
Страница 1: ......
