Page 9
SKU 66508
For technical questions, please call 1-800-444-3353
Pneumatic Foot Pedal (14A): Press On, release Off
Direction Lever (44-16): Pull Up: forward direction,
Center: neutral; Push down: slow reverse, Fast
reverse direction.
Attaching Guide Spring (48)
While following these procedures, it may be helpful to refer to the Parts List and Assembly
Drawings located at the end of this manual.
Unplug the Power Cord from the electrical outlet.
1.
Pull up on the Direction Lever (44-16) to place it in the NEUTRAL position.
2.
Loosen Tension Knob (44-13) and pull out three feet of cable from the Drum (38a).
3.
Slide the Guide Spring (48) over the cable and onto the Adapter (44-3) on the end of
4.
the Cable Feed Unit.
Pull out and align the Spring Loaded Pin (46) on the Guide Spring, with the hole in the
5.
Adapter (44-3).
Retighten Tension Knob (44-13).
6.
Select and Attach Proper Cutting Tool
There are four Cutting Tools included with the Drain Cleaner. Select the appropriate
tool for the cleaning job and attach to Cable (39a). Each is described in the table below.
Cutter Tool
Application
Arrow Cutting Head (59)
Starting tool for cutting and scraping
Auger Bulb (60)
Starting tool to remove loose objects
1-1/2” U-Cutter (61)
Finishing tool for grease stoppages and scraping pipe walls
1-1/4” Side Cutter Blade (62) Starting / Finishing tool to remove loose objects and scraping pipe walls
Select the desired cutter tool and insert it into the female connector located at the
1.
end of the Cable (39a). It is recommended to start with the Arrow Cutting Head (59)
or Auger Bulb (60). Once the drainpipe is opened, then use the 1-1/2 U-Cutter (61)
or 1-1/4” Side Cutter Blade (62) to scrape the inside wall of the drain pipe, for a more
Star Knob
(44-13)
REV 09b
