SKU 65796
For technical questions, please call 1-800-444-3353.
Page 8
TESTINg THE SEmI SEQuENTIAL
SAFETy TRIP mECHANISm
TO PREVENT
SERIOuS INjuRy
FROm ACCIDENTAL
OPERATION: Detach the
Battery and set the Trigger to
its “OFF” before performing
any inspection, maintenance,
or cleaning procedures.
TO PREVENT SERIOuS
INjuRy: Do not adjust or
tamper with any control or
component in a way not
specifically explained within
this manual. Improper
adjustment can result in
tool failure or other serious
hazards.
WARNINg!
Even though the Nailer should
be empty during this procedure, AL-
WAYS point the Nailer at a piece of
scrap wood when testing.
Disconnect the Battery from housing.
1.
Completely empty the Magazine of
2.
Fasteners.
The Nailer should not fire if the Nose
3.
of the Safety (24) is not depressed
against the workpiece.
Make sure the Trigger (3) and Nose
4.
move freely, without sticking.
Insert the Battery into the Housing.
5.
Test the tool by depressing the Nose
6.
against the workpiece without pulling
the Trigger.
The tool must not cycle
(fire).
If it cycles (fires), stop immedi
-
ately and have it repaired by a quali-
fied service technician.
Hold the tool away or off the work-
7.
piece in a safe direction. The Nose
should return to its original posi-
tion. Squeeze the Trigger.
The tool
should not cycle (fire).
If the tool
cycles (fires), stop immediately and
have it repaired by a qualified service
technician.
Depress the Nose against the work-
8.
piece and squeeze the Trigger.
The
tool must cycle (fire) only once.
Release the Trigger, reposition the
tool and squeeze trigger again.
The
tool must cycle (fire) only once.
With the Trigger held, carefully lift
the Nailer and press it against the
workpiece again.
The tool must not
cycle (fire).
If it fails to perform in
the manner explained in bold, have it
repaired by a qualified service techni
-
cian.
OPERATION
Figure B
Select Dial (8)
Battery (22)
Trigger (3)
Workpiece
Safety
Contact (7)
1. Once the Nailer/Stapler is fully
charged and loaded, turn the Select
Dial (8) to desired pressure setting.
See
Figure B
, above.
Please Note:
2.
The force required for
fastening depends on the type of
REV 08j
