Page 9
For technical questions, please call 1-888-866-5797.
Item 62356
SAFETY
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Operating Instructions
Read the ENTIRE IMpORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO pREVENT SERIOUS INJURY FROM AccIDENTAL OpERATION:
Make sure that the Trigger is in the off-position and unplug the tool from its
electrical outlet before performing any procedure in this section.
changing Bit Holders
1. Twist and pull forward on the Depth Collar to
remove it from the Head Cover, see Figure A.
2. Pull the Bit Holder straight out with
pliers if it is difficult to remove.
3. Push the new Bit Holder into the Spindle until
the shank of the Bit Holder snaps in place.
4. Replace the Depth Collar onto the Head Cover.
Align the ribs on the inside of the Depth Collar
with the grooves on the outside of the Head Cover
before snapping the Depth Collar in place.
Depth
collar
Bit
Holder
Spindle
Bit
Figure A: Remove Depth collar
changing the Bit
1. Twist and pull forward on the Depth Collar to
remove it from the Head Cover, see Figure A.
2. Pull the Bit straight out with pliers
if it is difficult to remove.
3. Push the new Bit into the Bit Holder until
the shank of the Bit snaps in place.
4. Replace the Depth Collar onto the Head Cover.
Align the ribs on the inside of the Depth Collar
with the grooves on the outside of the Head Cover
before snapping the Depth Collar in place.
Work piece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. Secure loose work pieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
General Operating Instructions
1. Make sure that the Trigger is in the
off-position, then plug in the tool.
2. Place the screw on the end of the bit.
3. Place the tip of the screw where it will be driven.
4. Drive the screw into place,
pulling back as soon as the clutch engages.
5. To prevent accidents, turn off the tool and
unplug it after use. Clean, then store the
tool indoors out of children’s reach.
Head cover
