Page 12
For technical questions, please call 1-800-444-3353.
Item 60713
SAFET
y
O
PERA
TION
M
AINTENAN
c
E
SETUP
Grinding, Abrasive cutting-off and Wire Brushing Instructions
TO PREVENT SERIOUS INJURy: Grip the tool firmly in both hands.
1. Make sure that the Power Switch is in the
“O” (OFF) position, then plug in the tool.
2. Press the Power Switch to the “I”
(ON) position to start the tool.
3. Allow the tool to come up to full speed
before touching the work material.
4. To create a smoother surface,
keep the tool moving over the work surface.
5. Press the Power Switch to the “O”
(OFF) position to stop the tool.
6.
TO PREVENT AccIDENTS, AFTER USE:
Turn off the tool.
WARNING! Allow the tool to come to a complete
stop before setting it down.
Unplug the tool. Clean, then store the
tool indoors out of children’s reach.
Sanding Instructions
TO PREVENT SERIOUS INJURy: Grip the tool firmly in both hands.
1. Wipe the work surface clean of all dirt and debris,
especially that of previous
coarser sanding sessions, which will scratch
the surface of a finer grit sanding session.
2. Make sure that the Power Switch is in the
“O” (OFF) position, then plug in the tool.
3. Press the Power Switch to the “I”
(ON) position to start the tool.
4. Allow the tool to come up to full speed
before touching the work material.
5. Keep heavy pressure off of the tool when operating.
Allow the tool to do the work.
6. Move the tool in a uniform pattern up and down or
side to side while sanding to ensure even sanding.
7. Press the Power Switch to the “O”
(OFF) position to stop the tool.
8. Periodically, stop the tool and check for disc wear.
Replace worn sanding discs as needed.
9.
TO PREVENT AccIDENTS, AFTER USE:
Turn off the tool.
WARNING! Allow the tool to come to a complete
stop before setting it down.
Unplug the tool. Clean, then store the
tool indoors out of children’s reach.
Maintenance and Servicing
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURy FROM AccIDENTAL OPERATION:
Make sure that the Power Switch is in the off-position and unplug the tool from
its electrical outlet before performing any procedure in this section.
TO PREVENT SERIOUS INJURy FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration occurs,
have the problem corrected before further use.
Содержание 60713
Страница 1: ......
