Page 13
For technical questions, please call 1-888-866-5797.
Item 56776
General Operating Instructions
DANGER!
MITER SAWS CAN QUICKLY AMPUTATE FINGERS IF MISUSED.
Keep hands well clear of cutting area.
1. Unlock the Head Lock-down, see page 9.
2. Make sure all adjustment knobs are
tight (Miter Knob, Bevel Lock Lever,
Table Extension Knobs).
3. Blow any sawdust or debris away from the Fence.
Place the work material against the Fence.
4. Align the marked location of the cut on
the work material with the saw blade.
Note:
To prevent your workpiece from being
cut too short, align the edge of the blade with
your measured mark, keeping the rest of
the blade on the waste side of the cut.
5. Hold the work material in place using the Clamp.
Ensure that the work material is level and supported
securely, use saw horses or supports if necessary.
6. Grip the Saw Handle, press one of the
Trigger Locks with your thumb, and
squeeze the Trigger to start the Saw.
7. Press down lightly to cut the material.
Do not bear down on the material, use
light downward pressure. If the material
binds the blade, release the trigger.
8. When the cut is completed, raise the blade
assembly, release the trigger, wait for the
Blade to stop turning, release the Clamp and
remove the work material from the saw.
9. To prevent accidents, turn off the tool and
disconnect its power supply after use. Clean, then
store the tool indoors out of children’s reach.
SAFETY
OPERA
TION
MAINTENANCE
SETUP
