Note:
Performance of this tool (if powered by line voltage) may vary depending on
variations in local line voltage. Extension cord usage may also affect tool
performance.
24.
Make certain that the power cord is kept clear of the Nylon Line,
failure to do so may
result in the power cord being cut, resulting in serious damage and injury.
Warning:
The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may
occur. It must be understood by the operator that common sense and
caution are factors which cannot be built into this product, but must be
supplied by the operator.
Warning:
This product contains or produces a chemical known to the State of
California to cause cancer and birth defects (or other reproductive
harm).
(California Health & Safety Code 25249.5 et seq.)
VOLTAGE WARNING
Before connecting the tool to a power source receptacle be sure the voltage supplied is about the
same as that specified on the nameplate of the tool. If one says 120V and the other says 110V
then there will be no complications. Never try to plug a 110V tool into a 220V outlet, or the other
way around. The plug and outlet have completely different shapes. This is because a power source
with a voltage greater than that spedified on the tool can result in a serious injury to the user-as well
as damage to the tool. If in doubt, do not plug in the tool.
Your tool is double insulated and has a two-prong plug. you may use either a two or three prong
extension cord. Only use rounded jacket extension cords. If you plan on indoor use, you may also
us an outdoor rated cord. Extension cords rated for outdoor use have the letters “WA” on the cord
jacket.
#47944
Page 4
Do not modify your plug in any way. If you have any doubt, call a qualified electrician.
Warning: People with pacemakers should consult with their physician before using this
product; operation of equipment in close proximity to a heart pacemaker could cause
interference or failure of the pacemaker.
Assembly
Your Electric Grass Trimmer-14” will require minor assembly prior to operation. It is important that
your read the entire manual to become familiar with the unit
BEFORE
you use the Grass Trimmer.
Before assembling your Electric Grass Trimmer be sure that you have all parts described in the
Parts List.
Attaching the Guard
Step 1)
Snap the Guard (#6)
into place at the base of the Electric Grass Trimmer. Line up
the two (2) prongs in the Motor Housing (#7)
with the two holes in the Guard (#6).
The Guard will snap into place and sit flush with the Motor Housing (#7)-see
Figure 1 on following page.
