Page 7
SKU 38437
Marking Slot Locations for Other Types of Cuts
When making preparations for cutting slots for T-butt, miter, edge-to-edge, leg and rail, and
square pattern joints, there are two important steps to ensure proper alignment of the joints.
1.
Align all boards as you want them to appear when finished, then mark the center line
for the slots on all boards at the same time.
.
Set plate depth before making cuts.
Maintenance
1.
Disconnect tool power before cleaning.
.
Wearing ANSI approved safety glasses, use compressed air to blow the tool clean.
3.
Do not insert pointed objects into holes in attempt to clean them out.
4.
Use a mild soap and clean, damp rag to clean tool.
Caution: Certain cleaning agents and solvents can damage plastic parts. Some of
these are: gasoline, carbon tetrachloride, chlorinated cleaning solvents, ammonia and
household detergents that contain ammonia.
