Page 6
SKU 38437
Locking On/Off Switch
The Plate Joiner Switch (35) is located under the Hold Covers (8 & 9). The black push button
on the left side of the cover locks the switch in the On position for long cutting operations.
1.
To turn the tool On without locking it, press and hold the Switch button in. When
pressure is released, the switch button snaps back to the Off position.
.
To lock the Switch On, press and hold the Switch button in, and then press in the black
pushbutton on the left side of the handle.
3.
To unlock the Switch from the On position, press and release the Switch button.
Typical Joiner Applications
Miter Joints T-Joints Edge to Edge Cuts Butt Joints
Marking Slot Locations for Standard Cuts
1.
Always begin with the Joiner base cutting into the end of the wood, rather than the
face as illustrated below.
.
Mark the center of slot at a point as least -1/ inches from outer edge of the board.
Allow at least 1 inch between slots in multiple plate applications for best results. Mark
all slots on both boards at the same time to assure proper alignment.
3.
Align center line on face plate with the pencil mark on wood as illustrated below.
4.
Grasp the tool with both hands, turn power On and push the tool forward smoothly.
When Joiner base assembly has butted completely against wood surface to be cut,
pull back and then turn power Off.
